website pop up marketing spanning-tree portfast
Cisco CCNA | CCNP Certification Training Site. Cisco tips and tools for exam success. logo video

spanning-tree portfast

Printer-Friendly Format

Command

Spanning-Tree Portfast

Use

This command essentially disables spanning-tree on an interface and brings it immediately into the forwarding state. Only use this command on access ports

Syntax

Switch(config-if)#spanning-tree portfast

Example


In the below example we will configure SW1's Fa0/2 to use port-fast to immediately skip to the forwarding state. First, we will flap Fa0/2 and observe how spanning-tree normally treats the interface.

SW1(config)#int fa0/2
SW1(config-if)#shut


The port goes through all the spanning tree timers. Here is the listening phase.

SW1(config-if)#do sh spanning vlan 10

VLAN0010
Spanning tree enabled protocol ieee
Root ID Priority 24586
Address 0012.00cb.6c80
This bridge is the root
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec

Bridge ID Priority 24586 (priority 24576 sys-id-ext 10)
Address 0012.00cb.6c80
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 15

Interface Role Sts Cost Prio.Nbr Type
---------------- ---- --- --------- -------- --------------------------------
Fa0/1 Desg FWD 19 128.1 P2p
Fa0/2 Desg LIS 19 128.2 P2p
Fa0/4 Desg FWD 19 128.4 P2p
Fa0/5 Desg FWD 19 128.5 P2p
Fa0/8 Desg FWD 19 128.8 P2p
Fa0/9 Desg FWD 19 128.9 P2p
Fa0/10 Desg FWD 19 128.10 P2p
Fa0/19 Desg FWD 19 128.19 P2p


Here is the learning phase.

SW1(config-if)#do sh spanning vlan 10

VLAN0010
Spanning tree enabled protocol ieee
Root ID Priority 24586
Address 0012.00cb.6c80
This bridge is the root
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec

Bridge ID Priority 24586 (priority 24576 sys-id-ext 10)
Address 0012.00cb.6c80
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 15

Interface Role Sts Cost Prio.Nbr Type
---------------- ---- --- --------- -------- --------------------------------
Fa0/1 Desg FWD 19 128.1 P2p
Fa0/2 Desg LRN 19 128.2 P2p
Fa0/4 Desg FWD 19 128.4 P2p
Fa0/5 Desg FWD 19 128.5 P2p
Fa0/8 Desg FWD 19 128.8 P2p
Fa0/9 Desg FWD 19 128.9 P2p
Fa0/10 Desg FWD 19 128.10 P2p
Fa0/19 Desg FWD 19 128.19 P2p


Finally the port is forwarding.

SW1(config-if)#do sh spanning vlan 10

VLAN0010
Spanning tree enabled protocol ieee
Root ID Priority 24586
Address 0012.00cb.6c80
This bridge is the root
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec

Bridge ID Priority 24586 (priority 24576 sys-id-ext 10)
Address 0012.00cb.6c80
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 15

Interface Role Sts Cost Prio.Nbr Type
---------------- ---- --- --------- -------- --------------------------------
Fa0/1 Desg FWD 19 128.1 P2p
Fa0/2 Desg FWD 19 128.2 P2p
Fa0/4 Desg FWD 19 128.4 P2p
Fa0/5 Desg FWD 19 128.5 P2p
Fa0/8 Desg FWD 19 128.8 P2p
Fa0/9 Desg FWD 19 128.9 P2p
Fa0/10 Desg FWD 19 128.10 P2p
Fa0/19 Desg FWD 19 128.19 P2p


Now we will configure portfast on Fa0/2.

SW1(config)#int fa0/2
SW1(config-if)#spanning portfast
%Warning: portfast should only be enabled on ports connected to a single
host. Connecting hubs, concentrators, switches, bridges, etc... to this
interface when portfast is enabled, can cause temporary bridging loops.
Use with CAUTION

%Portfast has been configured on FastEthernet0/2 but will only
have effect when the interface is in a non-trunking mode.


Notice how Fa0/2 is no longer seen in spanning tree.

SW1(config-if)#do sh spanning vlan 10

VLAN0010
Spanning tree enabled protocol ieee
Root ID Priority 24586
Address 0012.00cb.6c80
This bridge is the root
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec

Bridge ID Priority 24586 (priority 24576 sys-id-ext 10)
Address 0012.00cb.6c80
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 15

Interface Role Sts Cost Prio.Nbr Type
---------------- ---- --- --------- -------- --------------------------------
Fa0/1 Desg FWD 19 128.1 P2p
Fa0/4 Desg FWD 19 128.4 P2p
Fa0/5 Desg FWD 19 128.5 P2p
Fa0/8 Desg FWD 19 128.8 P2p
Fa0/9 Desg FWD 19 128.9 P2p
Fa0/10 Desg FWD 19 128.10 P2p
Fa0/19 Desg FWD 19 128.19 P2p
Fa0/20 Desg FWD 19 128.20 P2p



Back to commands department




Printer-Friendly Format

This site and/or material is not sponsored by, endorsed by, or affiliated with Cisco Systems, Inc. and/or its affiliates. Cisco®, Cisco Systems®, CCDA™, CCNA™, CCDP™, CCNP™, CCIE™, or CCSI™ are trademarks or registered trademarks of Cisco Systems, Inc. and/or its affiliates in the United States and certain other countries.

Home | Search | Contact Us | Tell a Friend | Text Size

2006-2013 HowtoNetwork.net All Rights Reserved. Reproduction without permission prohibited.
Reality Press, Midsummer Court, 314 Midsummer Blvd.,Milton Keynes, MK92UB, UK

This site is powered by MemberGate Membership Site Software