Command
Setup
Use
This command provides a simple wizard that helps you setup your router with a simple configuration. If you find yourself accidentally in setup mode (by pressing ‘yes’ when the router boots then hold down the control and c keys to exit.
Syntax
R1#setup
Example
In the below example, the setup command is demonstrated.
R1#setup — System Configuration Dialog — Continue with configuration dialog? [yes/no]: yes At any point you may enter a question mark ‘?’ for help. Basic management setup configures only enough connectivity Would you like to enter basic management setup? [yes/no]: yes Enter host name [R1]: The enable secret is a password used to protect access to The enable password is used when you do not specify an The virtual terminal password is used to protect Current interface summary Interface IP-Address OK? Method Status Protocol Enter interface name used to connect to the Enter interface name used to connect to the Configuring interface FastEthernet0/0: The following configuration command script was created: hostname R1 ! [0] Go to the IOS command prompt without saving this config. Enter your selection [2]: 2 |