howtonetwork.net

Cisco Certification Training

  • Products
  • CCNA
    • CCNA Videos
    • CCNA Lectures
    • CCNA Practice Exams
    • Challenge Labs
      • Challenge Video Solutions
    • Cisco Commands
  • CCNP ROUTE
    • ROUTE Exams
  • CCNP SWITCH
    • SWITCH Exams
  • CCNP TSHOOT
  • Home
  • Join
  • Downloads
  • About Us
  • Whitepapers
  • Feature Articles
  • Helpdesk
  • FAQ
  • Free Training
You are here: Home / Show Controller

Show Controller

Command

Show Controller

Use

This command displays very detailed controller and interface information. Most of the time, you will only use this command to see if a serial link is a DCE or a DTE.

Syntax

Router#show controller <interface>

Example

simple

In this example, we use show controller s1/1 | in DCE|DTE to see if the serial cable is DCE or DTE.

R1(config)#do sh controller s1/1 | in DCE|DTE
cable type : V.11 (X.21) DCE cable, received clockrate 2015232

Here is the full show controller output

R1(config)#do show controller
Interface FastEthernet0/0
Hardware is AMD Am79c971
ADDR: 644131C8, FASTSEND: 60037CDC, MCI_INDEX: 0
DIST ROUTE ENABLED: 0
Route Cache Flag: 11
LADRF=0x0020 0x0100 0x0008 0x0000
CSR0 =0x00000072, CSR3 =0x00001044, CSR4 =0x00004915, CSR15 =0x00000180
CSR80 =0x00001900, CSR114=0x00000000, CRDA =0x00000000, CXDA =0x00000000
BCR9 =0x00000001
CSR5 =0x00000001, CSR7 =0x00008000, CSR100=0x0000F000, CSR125=0x00005C00
BCR2 =0x00000000, BCR9 =0x00000001, BCR18 =0x00001960, BCR22 =0x00000000
BCR25 =0x000000FF, BCR26 =0x00000080, BCR27 =0x00000010, BCR32 =0x00000080
HW filtering information:
Promiscuous Mode Disabled, PHY Addr Enabled, Broadcast Addr Enabled
PHY Addr=CC01.1A80.0000, Multicast Filter=0x0020 0x0100 0x0008 0x0000
amdp2_instance=0x64414288, registers=0x3C000000, ib=0x7B237A0
rx ring entries=64, tx ring entries=128
rxring=0x7B23800, rxr shadow=0x64414840, rx_head=43, rx_tail=0
txring=0x7B23C40, txr shadow=0x64414974, tx_head=61, tx_tail=61, tx_count=0
Software MAC address filter(hash:length/addr/mask/hits):
0x54: 0 0100.5e00.000a 0000.0000.0000 0
0x57: 0 0100.5e00.0009 0000.0000.0000 0
0xC0: 0 0100.0ccc.cccc 0000.0000.0000 0
spurious_idon=0, filtered_pak=0, throttled=0, enabled=0, disabled=0
rx_framing_err=0, rx_overflow_err=0, rx_buffer_err=0
rx_bpe_err=0, rx_soft_overflow_err=0, rx_no_enp=0, rx_discard=0
tx_one_col_err=0, tx_more_col_err=0, tx_no_enp=0, tx_deferred_err=0
tx_underrun_err=0, tx_late_collision_err=0, tx_loss_carrier_err=0
tx_exc_collision_err=0, tx_buff_err=0, fatal_tx_err=0
hsrp_conf=0, need_af_check=0
tx_limited=0(64)
PHY registers:
Register 0x00: 1000 782D 0013 78E2 01E1 C9E1 000F 2001
Register 0x08: 0000 FFFF FFFF FFFF FFFF FFFF FFFF FFFF
Register 0x10: 0104 4780 0000 0000 0000 0000 0000
Register 0x18: 0000 0000 00C8 0000 FFFF

M4T: show controller:
PAS unit 0, subunit 0, f/w version 1-45, rev ID 0x2800001, version 1
idb = 0x64418B4C, ds = 0x64419C0C, ssb=0x64419FC8
Clock mux=0x0, ucmd_ctrl=0x1C, port_status=0x7B
Serial config=0x8, line config=0x200
maxdgram=1608, bufpool=78Kb, 120 particles
DCD=up DSR=up DTR=up RTS=up CTS=up
line state: up
cable type : V.11 (X.21) DCE cable, received clockrate 2015232

base0 registers=0x3C800000, base1 registers=0x3C802000
mxt_ds=0x644A07A4, rx ring entries=78, tx ring entries=128
rxring=0x7B724C0, rxr shadow=0x64420624, rx_head=28
txring=0x7B72780, txr shadow=0x64420A00, tx_head=67, tx_tail=67, tx_count=0
throttled=0, enabled=0
halted=0, last halt reason=0
Microcode fatal errors=0
rx_no_eop_err=0, rx_no_stp_err=0, rx_no_eop_stp_err=0
rx_no_buf=0, rx_soft_overrun_err=0, dump_err= 0, bogus=0, mxt_flags=0x0
tx_underrun_err=0, tx_soft_underrun_err=0, tx_limited=1(2)
tx_fullring=0, tx_started=1092, mxt_flush_count=0
rx_int_count=808, tx_int_count=1093
M4T: show controller:
PAS unit 1, subunit 1, f/w version 1-45, rev ID 0x2800001, version 1
idb = 0x64424434, ds = 0x644254F4, ssb=0x644258B0
Clock mux=0x0, ucmd_ctrl=0x0, port_status=0x7B
Serial config=0x8, line config=0x200
maxdgram=1608, bufpool=78Kb, 120 particles
DCD=up DSR=up DTR=up RTS=up CTS=up
line state: down
cable type : V.11 (X.21) DCE cable, received clockrate 2015232

base0 registers=0x3C800000, base1 registers=0x3C802000
mxt_ds=0x644A07A4, rx ring entries=78, tx ring entries=128
rxring=0x7B84900, rxr shadow=0x6442BF0C, rx_head=0
txring=0x7B84BC0, txr shadow=0x6442C2E8, tx_head=1, tx_tail=1, tx_count=0
throttled=0, enabled=0
halted=0, last halt reason=0
Microcode fatal errors=0
rx_no_eop_err=0, rx_no_stp_err=0, rx_no_eop_stp_err=0
rx_no_buf=0, rx_soft_overrun_err=0, dump_err= 0, bogus=0, mxt_flags=0x0
tx_underrun_err=0, tx_soft_underrun_err=0, tx_limited=1(2)
tx_fullring=0, tx_started=1, mxt_flush_count=1
rx_int_count=0, tx_int_count=3
M4T: show controller:
PAS unit 2, subunit 2, f/w version 1-45, rev ID 0x2800001, version 1
idb = 0x6442F268, ds = 0x64430328, ssb=0x644306E4
Clock mux=0x0, ucmd_ctrl=0x0, port_status=0x7B
Serial config=0x8, line config=0x200
maxdgram=1608, bufpool=78Kb, 120 particles
DCD=down DSR=down DTR=up RTS=up CTS=down
line state: down
cable type : V.11 (X.21) DCE cable, received clockrate 2015232

base0 registers=0x3C800000, base1 registers=0x3C802000
mxt_ds=0x644A07A4, rx ring entries=78, tx ring entries=128
rxring=0x7B96D40, rxr shadow=0x64436D40, rx_head=0
txring=0x7B97000, txr shadow=0x6443711C, tx_head=1, tx_tail=1, tx_count=0
throttled=0, enabled=0
halted=0, last halt reason=0
Microcode fatal errors=0
rx_no_eop_err=0, rx_no_stp_err=0, rx_no_eop_stp_err=0
rx_no_buf=0, rx_soft_overrun_err=0, dump_err= 0, bogus=0, mxt_flags=0x0
tx_underrun_err=0, tx_soft_underrun_err=0, tx_limited=1(2)
tx_fullring=0, tx_started=1, mxt_flush_count=1
rx_int_count=0, tx_int_count=2
M4T: show controller:
PAS unit 3, subunit 3, f/w version 1-45, rev ID 0x2800001, version 1
idb = 0x6443A0A8, ds = 0x6443B168, ssb=0x6443B524
Clock mux=0x0, ucmd_ctrl=0x0, port_status=0x7B
Serial config=0x8, line config=0x200
maxdgram=1608, bufpool=78Kb, 120 particles
DCD=down DSR=down DTR=up RTS=up CTS=down
line state: down
cable type : V.11 (X.21) DCE cable, received clockrate 2015232

base0 registers=0x3C800000, base1 registers=0x3C802000
mxt_ds=0x644A07A4, rx ring entries=78, tx ring entries=128
rxring=0x7BA9180, rxr shadow=0x64441B80, rx_head=0
txring=0x7BA9440, txr shadow=0x64441F5C, tx_head=1, tx_tail=1, tx_count=0
throttled=0, enabled=0
halted=0, last halt reason=0
Microcode fatal errors=0
rx_no_eop_err=0, rx_no_stp_err=0, rx_no_eop_stp_err=0
rx_no_buf=0, rx_soft_overrun_err=0, dump_err= 0, bogus=0, mxt_flags=0x0
tx_underrun_err=0, tx_soft_underrun_err=0, tx_limited=1(2)
tx_fullring=0, tx_started=1, mxt_flush_count=1
rx_int_count=0, tx_int_count=2

Get access to over 5 hours of IT webinar videos as well as regular study tips and ideas when you
join our mailing list

About This Site

We replaced this site some time ago with an upgraded version. Please feel free to enjoy the content and if you like what you see check out our brilliant new site:

howtonetwork.com

Keep In Touch

About Us

This is a free access website which has now been replaced by howtonetwork.com.

Navigation

  • Home
  • Join
  • Downloads
  • About Us
  • Whitepapers
  • Feature Articles
  • Helpdesk
  • FAQ
  • Free Training

Copyright

All content is protected by international copyright laws. Copyright Reality Press Ltd.

Copyright © 2023 · Dynamik Website Builder on Genesis Framework · WordPress · Log in